Re[2]: Lathe & Mill

Subject: Re[2]: Lathe & Mill
From: Richard <phebos-at-btinternet.com>
Date: Wed, 6 Nov 2002 18:58:43 +0000
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset=us-ascii
In-Reply-To: <200211061735.gA6HZGcC002485-at-btc1.up.net>
Organization: none
References: <1481803262234.20021106123736-at-btinternet.com> <200211061735.gA6HZGcC002485-at-btc1.up.net>
Reply-To: Richard <phebos-at-btinternet.com>


Hello Ray,

Wednesday, November 6, 2002, 5:46:01 PM, you wrote:

RH> Your trade is also a good fit with the EMC because it is open source.  
RH> When you see things that don't seem to work the way that you think they 
RH> should, change them.  

Yes, that part does sound appealing. What happens about driving
hardware under Linux?. If I made my own card with encoder
interface and DACs then I know I'm into EmcMot territory but is
anything else needed, like a device driver of some kind?

-- 
Best regards,
 Richard                            phebos-at-btinternet.com

Follow-Ups:
- Re: Lathe & Mill
  - From: Jon Elson <elson-at-pico-systems.com>
- Re: Re[2]: Lathe & Mill
  - From: Paul <paul.corner-at-tesco.net>
- Re: Re[2]: Lathe & Mill
  - From: Ray Henry <rehenry-at-up.net>

References:
- Lathe & Mill
  - From: Richard <phebos-at-btinternet.com>
- Re: Lathe & Mill
  - From: Ray Henry <rehenry-at-up.net>

Prev by Date: Re[2]: Lathe & Mill
Next by Date: Re: control panel
Prev by thread: Re: Lathe & Mill
Next by thread: Re: Re[2]: Lathe & Mill

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact