Re[2]: Lathe & Mill

[Richard <phebos-at-btinternet.com>]

Hello Jon,

Wednesday, November 6, 2002, 5:46:23 PM, you wrote:

JE> Yes, this is easy!  I often do this when testing, running different 
JE> setups on the same
JE> computer.  it only takes seconds to switch.

That's good news, at least. As for getting used to a new OS, if
I have to do it then I'll give it a go, but you know what they
say about old dogs and new tricks.

I just looked at the emc project page at Sourceforge and it says
:

"....It runs in real-time under Linux with the NMT rtlinux patch,
and in nonrealtime under Solaris, and WindowsNT."

Hmmm... has anybody built a working binary for NT, or knows what
is needed to do so?

-- 
Best regards,
 Richard                            phebos-at-btinternet.com