Re: need help compiling EMC

[Ray Henry <rehenry-at-up.net>]

Hi Hassan

What kind of drive amp are you using with this?  Is it microstep, half 
step, or full step?

Ray

On Friday 02 August 2002 10:50 pm, you wrote:
> am using steppermod....and i configured the ini file for 1
> inch/second2...max acceleration, 0.5 inch/second2....is there a certain
> procedure to determine all of these variables...i mean the acceleration
> and the velocity....when the motor starts to run ...the current will
> drop to 1.5 A...the power supp;y can provide 2 A....the voltage is 3.2
> V across the windings...and even with that current...i can easily stop
> the motor by holding the shaft with my fingers in the data sheet for
> the motor...it says that the motor can provide 2 N.m torque.
>
> regards
> hassan