Re: Follow-Error

["Ian Wright" <Ian-at-iw63.freeserve.co.uk>]

Hi Tim,

I found that, when I was trying steppermod in metric, I had to make
OUTPUT_SCALE 10% of INPUT_SCALE to get the display to show the correct
figures.
i.e. in my case INPUT_SCALE was 1200 and OUTPUT_SCALE had to be 120

Ian
--
Ian W. Wright
Sheffield  UK
www.iw63.freeserve.co.uk
----- Original Message -----
From: "Tim Goldstein" <timg-at-ktmarketing.com>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: 17 June 2001 21:18
Subject: RE: Follow-Error



Don't know if it makes any difference, but with steppermod I have always put
the output_scale parameter as 1. With Freqmod it has to be = to you steps
per inch.

Tim
[Denver, CO]

> -----Original Message-----
> From: emc-at-nist.gov [emc-at-nist.gov]On Behalf Of Malte Rütemann
> Sent: Sunday, June 17, 2001 1:51 PM
> To: Multiple recipients of list
> Subject: Follow-Error
>
>
> Hello,
> when I dirive the axes in manual mode I get a Follow-error after
> some time.
> Here is my conf.
> Thanks a lot
> Malte
>
>