Re: EMC Post Processor ?

["Darrell" <dgehlsen-at-earthlink.net>]

For a special "list" price on BobCAD, go to http://www.machinemqaster.com 
Darrell

----- Original Message ----- 
From: "Phil Smith" <phil-at-conwaycorp.net>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: Sunday, June 03, 2001 7:43 PM
Subject: Re: EMC Post Processor ?


> phil wrote:
> 
> > I've been looking into some CAM software packages recently and some of
> > them require a post processor to generate program code. Post
> > Processors appear to be normally supplied by the manufacturer of the
> > machine controller being used. If I'm using EMC as my controller what
> > should I do about a post processor ? thanks Phil
> 
> I personally dont have the funds to invest in a cad/cam package but to
> try to keep this from sounding like an advertisment,  i think that
> bobcad/cam is very nice,  its dos/windows baised but hey, its not a
> perfect world
> it does nurbs and other surfacing, very nice package,  below is a link
> to it
> 
> http://www.bobcadusa.com
> 
> its a nice system, i ran the demo for a while, very good stuff,
> Phil Smith
>