Re: EMC Homing Switches

[Spehro Pefhany <speff-at-interlog.com>]

At 02:40 PM 7/22/00 -0400, you wrote:
>
>Ok I'm finally getting around to putting homing switches on my machine.
>Problem is
>the EMC web site shows only pin 12 for homing all 3 axis'. If 3 switches
>are all
>connected to pin 12 in parallel, and I home the X axis, how do I then
>home the
>other two axis'? Do I need to add a 3 position switch to connect proper
>switch
>to the homing input when I'm ready to home that axis?

I don't see the problem.. only axis would be homed at once and the others
have to be 'away' from home.. 

Best regards, 


=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Spehro Pefhany --"it's the network..."            "The Journey is the reward"
speff-at-interlog.com             Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog  Info for designers:  http://www.speff.com
Contributions invited->The AVR-gcc FAQ is at: http://www.bluecollarlinux.com
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=