EMC Homing Switches

Subject: EMC Homing Switches
From: William Scalione <scalione-at-netarrant.net>
Date: Sat, 22 Jul 2000 13:37:49 -0500
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset=us-ascii
References: <E12M2k2-00018c-00-at-smtp01.mrf.mail.rcn.net> <00071918005600.00700-at-localhost.localdomain> <39768F0E.E4DC94FC-at-netarrant.net> <00072009490100.01723-at-localhost.localdomain>


Ok I'm finally getting around to putting homing switches on my machine.
Problem is
the EMC web site shows only pin 12 for homing all 3 axis'. If 3 switches
are all
connected to pin 12 in parallel, and I home the X axis, how do I then
home the
other two axis'? Do I need to add a 3 position switch to connect proper
switch
to the homing input when I'm ready to home that axis?

Thanks, Bill
scalione-at-netarrant.net

Follow-Ups:
- Re: EMC Homing Switches
  - From: Ray <rehenry-at-up.net>
- Re: EMC Homing Switches
  - From: Dan Falck <dfalck-at-sprynet.com>
- Re: EMC Homing Switches
  - From: Spehro Pefhany <speff-at-interlog.com>

References:
- Re: Feb. 17 EMC First look
  - From: "Matt Shaver" <mshaver-at-erols.com>
- Re: EMC following errors
  - From: Ray <rehenry-at-up.net>
- Re: EMC following errors
  - From: William Scalione <scalione-at-netarrant.net>
- Re: EMC following errors
  - From: Ray <rehenry-at-up.net>

Prev by Date: missing posts
Next by Date: Re: EMC Homing Switches
Prev by thread: Re: EMC following errors
Next by thread: Re: EMC Homing Switches

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact