rtlinux_2_0 mixed results...

[Clint Bach <clintbach-at-earthlink.net>]

Well, the good part is that rtlinux_2_0 for kernel2.2.13 is installed
and apparently running on my machine. The Frank, Zappa, test works and
the machine runs without complaining now. I followed the install.phil
instructions this time and it seems to work.

I'm slowly creeping up on the EMC part. The real time modules seem to
load without a complaint. Freqmod.o loads. My machine gets to a place
where it says "can't run minimillio" and stops. It will not get past
that place with bridgeportio either, FWIW. I wonder about the PLAT =
xxxx.
I put PLAT = rtlinux_2_0 since there are entries for it in
/usr/local/nist/emc/plat. What should really go there?

Recommendations? Oh yes, I also tried to install RH5.2 but it won't get
over the fact that I have it on hdc so it won't load the bootloader
(that's my story anyway). I didn't want to move the hard drive to hda...

Thanks for all the help.

BTW, this is not an emergency. I have plenty of time to sneak up on
this.

Clint