Re: rtlinux_2_0 mixed results...

[William Scalione <scalione-at-netarrant.net>]

Clint Bach wrote:
> 
> Well, the good part is that rtlinux_2_0 for kernel2.2.13 is installed
> and apparently running on my machine. The Frank, Zappa, test works and
> the machine runs without complaining now. I followed the install.phil
> instructions this time and it seems to work.
> 
> I'm slowly creeping up on the EMC part. The real time modules seem to
> load without a complaint. Freqmod.o loads. My machine gets to a place
> where it says "can't run minimillio" and stops. It will not get past
> that place with bridgeportio either, FWIW. I wonder about the PLAT =
> xxxx.
> I put PLAT = rtlinux_2_0 since there are entries for it in
> /usr/local/nist/emc/plat. What should really go there?
> 
> Recommendations? Oh yes, I also tried to install RH5.2 but it won't get
> over the fact that I have it on hdc so it won't load the bootloader
> (that's my story anyway). I didn't want to move the hard drive to hda...
> 
> Thanks for all the help.
> 
> BTW, this is not an emergency. I have plenty of time to sneak up on
> this.
> 
> Clint



Clint;

Just a guess, but are the parallel port addresses correct in
the Ini file? If the IO files are looking for non existant
ports it seems like it would not run too good. As I said,
just a guess.

Bill