Re: G-Code Problem

[Ray Henry <rehenry-at-up.net>]

Hi Andy

> minimilltool.cc 412: EMC_TOOL_MODULE: unknown command 1305

These kinds of IO error messages are the result of not using the correct 
pair of task and IO modules.  Probably you have bridgeporttask and 
minimillio defined and you should use minimilltask with minimillio or 
bridgeporttask with bridgeportio.

It isn't a big thing only an NML complaint about a message with nowhere 
to go.

Ray


On Wednesday 06 November 2002 06:04 pm, Andy wrote:
> Hello All!
>
> Thank you for your hints, I reduced the max_velocety and the P Value
> and now the G-Code Program is very well. Now I will experiment with
> these vlues to see what is the best config. I attached the EMC.INI. If
> you have more hints it would be great.  A little thing. At the end of
> the Program I get following Message:       Is there a problem?
>
> Motion id 403 took 0.165326 seconds.
> Motion id 0 took 0.000003 seconds.
> Issuing EMC_TRAJ_SET_ORIGIN --   (+224,+60,
> +0,0.000000,0.000000,0.000000,0.000000,0.000000,0.000000,)
> Issuing EMC_SPINDLE_OFF --       (+1305,+12,    +0,)
> minimilltool.cc 412: EMC_TOOL_MODULE: unknown command 1305
> emcTaskPlanClose() called at emctaskmain.cc:2795
> Issuing EMC_TASK_PLAN_SYNCH --   (+516,+12,    +0,)
> emcTaskPlanSynch() returned 0
>
> Many thanks to you all and best regards,
> Andy
>
> -----Ursprngliche Nachricht-----
> Von: emc-at-nist.gov [emc-at-nist.gov] Im Auftrag von Paul
> Gesendet: Mittwoch, 06. November 2002 00:44
> An: Multiple recipients of list
> Betreff: Re: G-Code Problem
>
>
>
> Hi Andreas
>
> Must be a metric setup with a feed rate of 800 !!
>
> First thing to try is turning down the MAX_VELOCITY and
> MAX_ACCELERATION
>
> parameters. Turning down the P gain may also help if you're using
> freqmod.
>
> Perhaps if you posted the ini file you're using, along with a brief
> description of the mill and hardware, we could give you a more detailed
> answer.
>
> Regards, Paul.
>
> On Tuesday 05 Nov 2002 11:12 pm, Andreas Scheuch wrote:
> > G-Code Program. The first steps (lines in code) are working very
> > well. Machine follows the commands correct. But suddenly the Machine
> > stops
>
> and
>
> > in the G-Code window the cursor stands on line N940. A window opens
>
> with
>
> > "AXIS 0 following error" no more text stands in the Window. When I
>
> start
>
> > EMC in a Terminal Window I can see a little bit more information on
>
> the
>
> > Error: