AW: G-Code Problem

["Andreas Scheuch" <andreas.scheuch-at-aon.at>]

Hello again!

I forgot something.

What'S about the Version BDI EMC 2.15 (2.16) and 2.18.

Should I install a newer Version?
Best regards,
Andy

-----Ursprüngliche Nachricht-----
Von: emc-at-nist.gov [emc-at-nist.gov] Im Auftrag von Paul
Gesendet: Mittwoch, 06. November 2002 00:44
An: Multiple recipients of list
Betreff: Re: G-Code Problem



Hi Andreas

Must be a metric setup with a feed rate of 800 !!

First thing to try is turning down the MAX_VELOCITY and MAX_ACCELERATION

parameters. Turning down the P gain may also help if you're using
freqmod.

Perhaps if you posted the ini file you're using, along with a brief 
description of the mill and hardware, we could give you a more detailed 
answer.

Regards, Paul.



On Tuesday 05 Nov 2002 11:12 pm, Andreas Scheuch wrote:
> G-Code Program. The first steps (lines in code) are working very well.
> Machine follows the commands correct. But suddenly the Machine stops
and
> in the G-Code window the cursor stands on line N940. A window opens
with
> "AXIS 0 following error" no more text stands in the Window. When I
start
> EMC in a Terminal Window I can see a little bit more information on
the
> Error: