MEI LC/DSP Doc Password?

["Till Franitza" <xfa-at-isw.uni-stuttgart.de>]

Hi!
I tried to look at the docu but i had no password. What can I do?
till

> -----Ursprüngliche Nachricht-----
> Von: emc-at-nist.gov [emc-at-nist.gov]Im Auftrag von Malte Rütemann
> Gesendet: Montag, 7. Oktober 2002 06:44
> An: Multiple recipients of list
> Betreff: Re: EMC/SDK/Linux control of MEI LC/DSP 4 axis servo
> controller?
>
>
>
> Am Sonntag, 6. Oktober 2002 19:43 schrieben Sie:
> > Hi.
> > I've just bought an Motion Engineering (MEI) LC/DSP 4
> > axis servo controller board (hoping in vain to save
> > money), but discovered that I cannot come close to
> > affording the SDK for it (and it is for Windows
> > anyhow).
> > Specs are at:
> > http://www.motioneng.com/dsp_series.html    (quick
> > description sheet)
> > ftp://ftp.motioneng.com/manuals/DSP/DSP%20Manual%20Set.zip
> >   (manuals)
> >
> > It is an ISA bus, 4 axis servo control card, uses an
> > Analog Devices  ADSP-2105 chip.
> > Numbers on the DSP chip: ADSP-2105, KP-80,
> > LRU30137-2.2, 9943
> >
> >
> > I would like to run this board under Linux to control
> > a CNC machine.
> >
> > I'm a competent programmer, but have no experience
> > with these boards.
> >
> >
> > Does anybody have drivers or an SDK for these or
> > similar boards for Linux?  I know about EMC and the
> > Servo to Go 8 axis board (wish I could afford one...).
> >
> > What are the necessary steps and data for creating the
> > drivers or an SDK for this board?  I might be able to
> > get some hardware info for it.
> >
> > http://www.motioneng.com/dsp_series.html    (quick
> > description sheet)
> > ftp://ftp.motioneng.com/manuals/DSP/DSP%20Manual%20Set.zip
> >   (manuals)
> >
> > Any help is greatly appreciated!
> > Thanks!
> > -Ralph
> > rpseguin AT yahoo DOT com
> Hi,
> how much did this board cost???
> Malte
>