Re: EMC/SDK/Linux control of MEI LC/DSP 4 axis servo controller?

[Malte Rütemann <malte-at-micompan.de>]

Am Sonntag, 6. Oktober 2002 19:43 schrieben Sie:
> Hi.
> I've just bought an Motion Engineering (MEI) LC/DSP 4
> axis servo controller board (hoping in vain to save
> money), but discovered that I cannot come close to
> affording the SDK for it (and it is for Windows
> anyhow).
> Specs are at:
> http://www.motioneng.com/dsp_series.html    (quick
> description sheet)
> ftp://ftp.motioneng.com/manuals/DSP/DSP%20Manual%20Set.zip
>   (manuals)
>
> It is an ISA bus, 4 axis servo control card, uses an
> Analog Devices  ADSP-2105 chip.
> Numbers on the DSP chip: ADSP-2105, KP-80,
> LRU30137-2.2, 9943
>
>
> I would like to run this board under Linux to control
> a CNC machine.
>
> I'm a competent programmer, but have no experience
> with these boards.
>
>
> Does anybody have drivers or an SDK for these or
> similar boards for Linux?  I know about EMC and the
> Servo to Go 8 axis board (wish I could afford one...).
>
> What are the necessary steps and data for creating the
> drivers or an SDK for this board?  I might be able to
> get some hardware info for it.
>
> http://www.motioneng.com/dsp_series.html    (quick
> description sheet)
> ftp://ftp.motioneng.com/manuals/DSP/DSP%20Manual%20Set.zip
>   (manuals)
>
> Any help is greatly appreciated!
> Thanks!
> -Ralph
> rpseguin AT yahoo DOT com
Hi,
how much did this board cost???
Malte