Re: following error question

Subject: Re: following error question
From: Paul <paul.corner-at-tesco.net>
Date: Sat, 5 Oct 2002 18:29:38 +0100
Content-Transfer-Encoding: 8bit
Content-Type: text/plain; charset="utf-8"
In-Reply-To: <3D9DD766.3050407-at-1st.net>
References: <000b01c26996$61a1f4d0$f500a8c0-at-LOGE> <200210041438.g94EcUeM014561-at-btc1.up.net> <3D9DD766.3050407-at-1st.net>

Hi Dale

Try adding a little deadband to the ini file - I have one setup that I'm 
currently tuning with DEADBAND = 0.0002 and it has made a major difference.

Regards, Paul.

On Friday 04 Oct 2002 6:58 pm, Dam wrote:
> The growling or
> grinding sound that I mentioned is caused by EMC throwing in some
> reverse direction pulses in an attempt to slow the motor down.

References:
- following error question
  - From: "Richard Everett" <res0jyup-at-verizon.net>
- Re: following error question
  - From: Ray Henry <rehenry-at-up.net>
- Re: following error question
  - From: Dam <damg-at-1st.net>

Prev by Date: Re: smdromod success
Next by Date: EMC/SDK/Linux control of MEI LC/DSP 4 axis servo controller?
Prev by thread: Re: following error question
Next by thread: Re: following error question

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact