Re: need help compiling EMC

["Hassan Rabe" <rabeh-at-student.gvsu.edu>]

hello list.
i have a problems with controlling a stepper motor...that delivers 0.25
degree per pulse...when i calculated the required pulses per inch ...it was
11520..which i think a lot....but it worked out fine with EMC.....but my
problem is that i can't get the feed rate to go over 9....and the axis speed
to go over 10....the settings are in inches...
the motor is a 2 phase unipolar stepper motor...2A DC, ...i built the
controller ..its mainly an EDE1200 microcontroller and a some transistors,
diods and resistors...when i go over the above values...the motor starts to
vibrate without moving...am not sure if this is EMC problem or controller or
the motor...it's really frosterating ...after you build the hole thing...and
it's moving so slow...that you can't notice it's moving...
please help

hassan