Base address of servo to go board.

[Webstercnc-at-aol.com]

Hi Everyone,

I want to use encoders with my steppers and I
have a Camtronics Dro board.  In the generic.ini
file at the [EMCMOT] section. There is an entry
that says; Base address of servo to go board
              STG_BASE_ADDRESS =      0X200
              ;   STG_BASE_ADDRESS=   0X300

Is this where I would put my DRO board address (544D)?
If yes, Would this be correct if I modify my first address 
to read STG_BASE_ADDRESS       =       0X544D      ?

Thanks,

Juan