Re: Memory requirements

["Matthew King" <mattking-at-knology.net>]

I'll let y'all know as soon as I try it!

Thanks,

Matt


-----Original Message-----
From: Paul <Paul.Corner-at-tesco.net>
To: Multiple recipients of list <emc-at-nist.gov>
Date: Sunday, July 22, 2001 11:33 AM
Subject: Re: Memory requirements


>
>
>Hi Matt
>
>You shouldn't have any problems running a Cyrix processor with a BDI
install.
>Much of the early work I did on the CD was with one these chips and 128Mb
>memory. Unfortunately it died a few months back (suspect a dodgy SIMM), and
I
>used the opportunity to upgrade.
>
>Must have a look at getting it back to life sometime.
>
>Regards, Paul.
>
>
>On Sun, 22 Jul 2001, Matthew King wrote:
>> I've got a question for y'all, and I suspect I know the answer - Am I
going
>> to run into trouble when I try to install the BDI on a Cyrix P233 clone?
>> Opinions? To change it, I'd have to get a new motherboard as well(it's a
>> generic import model). This is my wife's old machine and the MB manual
has
>> been gone for quite sometime now. If I go that route, I'll hunt down an
>> early PIII board and processor and flood it with RAM and have an EMC
machine
>> for the next millenium!
>>
>> Thanks guys, this list has taught me immense amounts about EMC and CNC in
>> general.
>>
>> Take care,
>>
>> Matt King
>> Columbus, GA
>
>