Re: Servo To Go v2 8axis EMC interface woes

[Paul <Paul.Corner-at-tesco.net>]

Hi Keith

I cut and pasted your ini file over to one of the test machines here - Apart
from the Min following error settings which may give you problems later, the
one setting that needed correcting was COM_TIMEOUT
Changing it to 1.0 rather than the low value of 0.01 that you had it at
produced a running EMC. The limit polarities are wrong for me, but that is a
minor issue.

Regards, Paul.



On Wed, 27 Jun 2001, Keith Rumley wrote:
> Hello all,
> 
>     I'm having difficulty with the IO control with the STG2 8axis board (I'm
> using 3 axes currently). There are several things, probably inter-related.
> 
>     Various related error listings are appended, with my .run mod for the
> stg_v2_8axis_mod.o, and .ini listing.