Re: Servo To Go v2 8axis EMC interface woes

["Keith Rumley" <dscadcam-at-yahoo.com>]

Paul,

Changing the COM_TIMEOUT setting to 1.0  did the trick!

( I'll not have a chance to check it out connected to the mill 'til next
week.)

Thanks!

 - Keith


----- Original Message -----
From: "Paul" <Paul.Corner-at-tesco.net>

> ...
> I cut and pasted your ini file over to one of the test machines here -
Apart
> from the Min following error settings which may give you problems later,
the
> one setting that needed correcting was COM_TIMEOUT
> Changing it to 1.0 rather than the low value of 0.01 that you had it at
> produced a running EMC. The limit polarities are wrong for me, but that is
a
> minor issue.
>



_________________________________________________________
Do You Yahoo!?
Get your free -at-yahoo.com address at http://mail.yahoo.com