Re: feedrate

["Joel Jacobs" <jj-at-spyparts.com>]

Yes I know that.  But if I stay in MDI mode and set the feedrate to F2 it
says F2 in the status bar reguardless if Im doing a G0 or a G1.  It doesn't
change when I do a G0, it's just ignored for a rapid traverse.

Read my message again - I don't think it's acting right...

> G0 is a rapid move at the max feed rate. G1 is a linear move at the
selected
> feed rate.
> Sounds as if it is working just as it should.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> > From: emc-at-nist.gov [emc-at-nist.gov]On Behalf Of Joel Jacobs
> > Sent: Sunday, March 18, 2001 7:40 PM
> > To: Multiple recipients of list
> > Subject: feedrate
> >
> >
> >
> > Hi all,
> > Quick question,  If I'm in MDI mode and set the feedrate to F2 then go
to
> > manual mode and jog an axis, then go back to MDI mode, the
> > feedrate is still
> > displayed as F2 but as soon as I move an axis (G0x0) - the feedrate
> > displayed in the status line jumps to F25.  Thats the max feedrate from
my
> > ini file.  It suppose to do this?  I would rather it not change unless I
> > change it or run a program that changes it.
> >
> > Joel
> >
> >
>
>