RE: feedrate
G0 is a rapid move at the max feed rate. G1 is a linear move at the selected
feed rate.
Sounds as if it is working just as it should.
Tim
[Denver, CO]
> -----Original Message-----
> From: emc-at-nist.gov [emc-at-nist.gov]On Behalf Of Joel Jacobs
> Sent: Sunday, March 18, 2001 7:40 PM
> To: Multiple recipients of list
> Subject: feedrate
>
>
>
> Hi all,
> Quick question, If I'm in MDI mode and set the feedrate to F2 then go to
> manual mode and jog an axis, then go back to MDI mode, the
> feedrate is still
> displayed as F2 but as soon as I move an axis (G0x0) - the feedrate
> displayed in the status line jumps to F25. Thats the max feedrate from my
> ini file. It suppose to do this? I would rather it not change unless I
> change it or run a program that changes it.
>
> Joel
>
>
- References:
- feedrate
- From: "Joel Jacobs" <jj-at-spyparts.com>
Date Index |
Thread Index |
Back to archive index |
Back to Mailing List Page
Problems or questions? Contact