Modifying EMC interface for lathe (x and z) display

["Howard Bailey" <bogmstr-at-infomagic.net>]

I was wondering how one would modify TKEMC to only display the readouts for
the X and Z axes for a lathe.  I have looked at some of the files and what I
needed was not apparent to me.  Additionally, I was wondering how difficult
it would be to have one version of EMC set up to run a mill and another to
run a lathe on the same computer to be able to choose the proper version for
the job at hand.  More specifically, which files I would need two versions
of and which references to these files in the .ini files I would need to
modify.  Any help is appreciated.

Regards,

Howard Bailey