Re: endpoint radius errors with i,j commands

["Shelbyville Design & Signworks" <signworks-at-mcleodusa.net>]

perhaps a talk through a compile would be easiest....

Erie Patsellis
Shelbyville Design & Signworks
1309 W. S. 7th Street
Shelbyville, IL 62565
(217)774-4444
visit our website at www.shelbyvilledesign.com
----- Original Message -----
From: "Paul" <paul.corner-at-tesco.net>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: Thursday, November 07, 2002 2:59 PM
Subject: Re: endpoint radius errors with i,j commands


>
>
> Hi Erie
>
> Afraid a full compile is the only way out..
>
> In emc/src/rs274ngc_new.hh change TOLERANCE_INCH and TOLERANCE_MM to suit
> your needs. TOLERANCE_CONCAVE_CORNER might also benefit from being
increased
> slightly.
>
> On the TNG, make sure you have compat-egcs installed, and edit
> rcslib/etc/rtai.def and linux_rtai.def so that the CC = kgcc (or egcs).
The
> gcc (2.96) supplied by RedHat does not compile working realtime code.
>
> Regards, Paul.
>
>
> BTW, the latest TNG installs compat-egcs and allready has the changes made
to
> the *.def files.
>
> On Thursday 07 Nov 2002 4:53 pm, Shelbyville Design & Signworks wrote:
> >  I've tried setting my s/w (signlab) to 4 dec.
> > point precision (something you can't do with enroute) and
> > am still getting the errors. I suspect this would increase my
> > speed, as it presently cuts lots of short segments instead
> > of a nice steady curve.
> > Any suggestions?
>
>
>