Re: following error question

Subject: Re: following error question
From: Paul <paul.corner-at-tesco.net>
Date: Tue, 1 Oct 2002 23:24:28 +0100
Content-Transfer-Encoding: 8bit
Content-Type: text/plain; charset="iso-8859-1"
In-Reply-To: <000b01c26996$61a1f4d0$f500a8c0-at-LOGE>
References: <000b01c26996$61a1f4d0$f500a8c0-at-LOGE>

Hi Richard

Set input_scale to 5000 and output_scale to 1 and try again.
These two parameters only need to be equal if you are using freqmod.

Regards, Paul.

On Tuesday 01 Oct 2002 11:12 pm, Richard Everett wrote:
> I then setup the emc.ini file with steppermod.o and input scale and output
> scale set to 5000.

References:
- following error question
  - From: "Richard Everett" <res0jyup-at-verizon.net>

Prev by Date: following error question
Next by Date: Re: First time EMC user (introduction)
Prev by thread: following error question
Next by thread: Re: following error question

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact