RE: Runaway z axis with steppers

["Tim & Heather Smith" <thdsmith-at-bigpond.com>]

>EMC List
>I posted this a while back to the developers list at sourceforge but I
>don't think that that list is working so I'll post it here.
>Attached is an ini from Tim <tim.smith-at-electrolux.com.au> that does some
>goofy stuff here.  I'm not exactly going to call it a bug, rather the odd
>behavior is the product of certain combinations of values in the ini file
>when used with freqmod.o.  The same behaviors are not obvious with
steppermod.

Ray,

I have since constructed a reduction box for the motor on the Z axis.
It is now running at 48 steps/mm, and has been performing well.

Thanks for the interest in this one.

Regards Tim Smith