RE: EMC Scaling problem

Subject: RE: EMC Scaling problem
From: "Tim Goldstein" <timg-at-ktmarketing.com>
Date: Thu, 22 Aug 2002 23:50:16 -0600
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset="us-ascii"
Importance: Normal
In-Reply-To: <3D65AF6D.1070609-at-bellsouth.net>
Reply-To: <timg-at-ktmarketing.com>


Try 10000

Tim
[Denver, CO]

> -----Original Message-----

> We have installed EMC ,(using BDI) on a Bridgeport Mill and are 
> evaluating performance on a single axis before proceeding into a 
> complete retrofit.
> 
>    Positioning is accurate and repeatable and responce satisfactory 
> however scaling is off by 10.
>    A command, manual or MDI, of  one 1 inch will produce an 
> displacement 
> of 0.1 inch,etc..
> 
> Calculated  INPUT_SCALE is 1000 from 200 steps per revolution, 5 
> revolutions/inch.
> 
> We have reviewed all available sources of information with no 
> luck. Any 
> help would be appreciated.
>                             mjp

References:
- EMC Scaling problem
  - From: helga/michael <MPALFRAM-at-bellsouth.net>

Prev by Date: EMC Scaling problem
Next by Date: Re: EMC Scaling problem
Prev by thread: EMC Scaling problem
Next by thread: Re: EMC Scaling problem

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact