Re: Newbie question

[rehenry-at-up.net]

Hi Mark

Glad your using the EMC.  I made a version of ex a while ago that had
both a spindle speed display and an override bar but I don't believe
that these things have not been implemented in the task or motion code.
 I did a feedrate dislay for the same interface.  All I did for it was
multiply current feedrate by feedrate override.  This is fairly accurate
if the axes are tuned so that they will run at the expected rate.  When
I get back home, I'll dig into my stuff and see if I can find what I did
with this.

If you don't hear from me for a while, whatever that means to you get
back to me.

Ray

> 
> Is it possible to get emc to display the current feed and spindle
speed in the auto screen

> 
> im using tkemcex
> 
> mark
> 
> 
> 
> ---------------------------------
> Relive the FIFA World Cup goals with exclusive video highlights!
> 
> http://fifaworldcup.yahoo.com/fc/en


---------------------------------------------
This message was sent via GetMail
Check your up.net email:  http://getmail.up.net