Re: Servo motor controller project

Subject: Re: Servo motor controller project
From: Paul <paul.corner-at-tesco.net>
Date: Tue, 28 May 2002 23:14:03 +0100
Content-Transfer-Encoding: 8bit
Content-Type: text/plain; charset="iso-8859-1"
In-Reply-To: <000c01c205e1$0c4e3e30$0100a8c0-at-nvdwpc>
References: <000c01c205e1$0c4e3e30$0100a8c0-at-nvdwpc>

Hi Nic

A PCI interface need not be either expensive or complex - I've been doing 
some work over the last few days with the PLX 9050. It is not too hard to 
use, and it is also reasonably priced.

Regards, Paul.

On Tuesday 28 May 2002 1:54 am, Nic van der Walt wrote:
> The core design can easily be used to progress towards both a PCI based
> board, and a USB
> based board. I'm concerned about latency problems using USB, and
> cost/complexity issues with
> PCI.

References:
- Servo motor controller project
  - From: "Nic van der Walt" <nic-at-unibell.co.za>

Prev by Date: Servo motor controller project
Next by Date: Saving G-codes file/EMC
Prev by thread: RE: Servo motor controller project
Next by thread: Servo motor controller project

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact