Re: Re: need your opinion!

Subject: Re: Re: need your opinion!
From: "Hassan S. Rabe" <RABEH-at-student.gvsu.edu>
Date: Mon, 20 May 2002 21:19:58 GMT
Content-Transfer-Encoding: 8bit
Content-type: text/plain; charset=utf-8


am using the MAXNC 10C machine, it has a bipolar steppers 
with 18 W, 1500 RPM, Vs 65, 1.8 steps.
the driver is the same driver on the maxnc....should i get 
the parameters of the driver??? it accepts foure phase 
signal ...so i mad a small circut to convert the step/dir 
into the foure phase required by the machine

Prev by Date: Re: Servo controller
Next by Date: Re: Servo controller
Prev by thread: RE: Stepper Controller Schematic
Next by thread: Programming with Variables

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact