Re: G code questions?

[Ray Henry <rehenry-at-up.net>]

Joe

It is possible to use the flood or mist coolant commands for this if you have 
a second parport and can run the bridgeporttask and bridgeportio or tkio.  In 
addition, you will need to examine the time required for the z change and 
program a dwell in the next block.

Hope this helps.

Ray


On Thursday 18 April 2002 08:48 pm, you wrote:
> List
>    First thing is that I would like thank all of the list members for there
> response to my question. Each reply added to the one before it. There
> certainly is a wealth of knowledge out there.
>    I am now able to draw entire words. The thing I need to know is the
> M-code for up and down. I have a two axis machine where an air cylinder
> raises and lowers the router. I can't find this command any where.
<s>