Re: archive

[Ray Henry <rehenry-at-up.net>]

At 03:29 AM 8/3/1999 -0400, you wrote:

>         the second page indicates that the page is limited to NIST  staff.
>  Can you advise how to get more information.   Regards,   J. Neven 
 
They have been working on making that archive open but seem not to have
succeeded as yet.  There is an archive of CAD_CAM_EDM_DRO on Onelist that
has a number of postings on the EMC software.  

http://www.onelist.com/arcindex.cgi?listname=CAD%5FCAM%5FEDM%5FDRO and can
search the archive from there.

You can join Mailing-List: list CAD_CAM_EDM_DRO-at-onelist.com; contact
CAD_CAM_EDM_DRO-owner-at-onelist.com

Jon Elson is in charge of the FAQ for that list.  You can find the
partially completed FAQ and good EMC info at 

http://206.19.206.56/cadfaq.htm

Jon runs a converted round-ram bridgeport with EMC software.  You can see
some of his project at

http://ascc.artsci.wustl.edu/~jmelson/CNCconv.html

Matt Shaver also converts bridgeports to run with the EMC software.  You
can see some of his work at
 
http://206.19.206.56/cadfaq.htm

I hope that this helps.  BTW what kind of machine are you trying to run?
What interface system are you using?  What motors and amps?

I see .be in your address.  Where are you located?

Ray Henry