Re: Unclamp_Axis

[Paul <paul.corner-at-tesco.net>]

Hi Kurtis

The basic canonical commands are already in EMC, and I'm sure I've seen some 
notes in the inerpreter as well. Altough the basic functions are there, they 
have not been enabled, so you would have to do some hacking to get some 
useable outputs.

Regards, Paul.


On Thursday 14 February 2002 5:02 pm, Kurtis Martineau wrote:
> Is there a way to use EMC with axis brakes?
>
> If so, how could I go about applying this function?
>
> My application uses brakes on the X and Z axis'.  I have the brakes
> currently wired so that  the brakes are unclamped when EMC is in machine-on
> mode.  The original AB 7300 would clamp the axis' when motion stopped and
> unclamp when motion was being commanded.
>
> Kurtis