Re: EMC Display

["William Scalione" <wscalione-at-nc.rr.com>]

Fred,

I remember something about World and Joint Coordinates. Switch to world
in the ini file??? I looked in my ini file and could'nt find that but I am
running
an older version.

Bill
>
>
> Now I have been learning a lot, and am now getting very keen about finally
> getting this project near completion.
>
> I want to change the display within EMC, and heres what I want to do.
>
> Change the 0, 1, 2 in 3 axis, or 0, 1, 2, 3 in four axis to read X, Y, Z
or
> X, Y, X, A
>
> I cant seem to see anything that is relevant in the INI file. Am I looking
in
> the wrong place, where should I be looking, or can it even be done ?
>
>
> Many thanks
>
>
> Fred
>
>
>
> Disclaimer:
> The content and attachment/s of this message have passed our virus
scanning process. Whilst we believe this message to be safe, we encourage
the use of your own preventative measures.
>
> The information contained in this E-mail is CONFIDENTIAL and may be
LEGALLY PRIVILEGED, intended only for the recipient named above.  If you are
not the intended recipient, you are notified that any use, review,
dissemination, distribution or copying of this message is strictly
prohibited.  If you have received this message and attachments in error,
please notify the sender and destroy the original message. You are also
notified that the views expressed in this E-mail do not necessarily reflect
those of the company.
>
>
>
>
>
>