following error

Subject: following error
From: "Ed Okerson" <eokerson-at-fw.telenic.net>
Date: Mon, 12 Nov 2001 19:10:42 -0600
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset="iso-8859-1"


Well, I got EMC to control the steppers. :)  When running the CDS.ngc that
comes with it, all seems fine for a while.  It runs down the first side of
the circle and comes across the bottom, then pulls the tool up and pops up
an error box that says "Axis 2 following error".  What the heck does that
mean?  I have no encoders hooked up to anything, and am running
steppermod.o.  Any suggestions?

Ed Okerson

Prev by Date: EMC buffer question
Next by Date: Re: following error
Prev by thread: Re: following error
Next by thread: Re: following error

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact