RE: Updated RPM for BDI

[Ray <rehenry-at-up.net>]

Ethan

These are intended to be Paul's official replacement for the 801
experimental stuff.  They do not have some of the latest features (inch/mm
and joint/world) in the tkemc gui but we (you) have found some trouble with
them.  For running a machine, these would be stable and good.  And you can
make the estop button do what you want using the code I posted recently.

Ray 


On Wed, 05 Sep 2001, you wrote:
> How does this relate to the 801bin files that I just updated with?
> 
> Ethan
> 
> 
> -----Original Message-----
> From:	Paul [SMTP:Paul.Corner-at-tesco.net]
> Sent:	Tuesday, September 04, 2001 5:27 PM
> To:	Multiple recipients of list
> Subject:	Updated RPM for BDI
> 
> 
> 
> Hi Folks
> 
> Just posted two updated packages for EMC running on a BDI install. You will
> need both the emc-rtl3.0-2.10.i586.rpm and rcslib-rtl3.0-2.10.i586.rpm from
> http://www.linuxcnc.org/bdi/RPMS/rpm.html
> Some of the reported bugs have been fixed (I hope) along with some minor
> changes to the source code. Note, this is not based on the latest CVS stuff,
> rather the original BDI/EMC source code.
> 
> If you have any problems, just shout.
> 
> Regards, Paul.