RE: EMC up and running but how to reverse Z

[Tim Goldstein <tgoldstein-at-mlh-services.com>]

You do it in the software by putting a negative (-) in front of your
inputscale value. You may have to do the same to the outputscale if you are
using some of the motion modules.

Tim
[Denver, CO]


> 
> * Doug Fortune (pentam-at-home.com) [24.01.2001 04:25]:
> > ...
> > can't you just swap the leads on your Z axis (stepper or 
> servo) motor?
> 
> Oh. ;-) Indeed. Sometimes obvious answer is just there. Thank you very
> much ! Now I got all axis as I want them to be. Thank you again ;-) !
> And now I'm going to finetune those backslash settings...
> 
> Regards,
> 
> Henkka
>