Re: gotit! emc on 2.2.14 Thanks Ray

["Derek B." <hightechsystems-at-home.com>]

Question will this work with red hat 6.2?
thanks 
Derek B.

"andrew a." wrote:
> 
>   Ok, I installed emc on red hat 6.1 again, this time
> I took better notes!
> 
>    My setup is
> 
>      red hat 6.1
>      gnome workstation install
>      rtlinux-2.2-prepatched.tar.gz file from site
> listed on linuxcnc.org
>      june 7 emc
> 
>    Just two small differences,
> 
>  First, the rtlinux install
> 
>    After following all directions on installing the
> rtlinux-2.2 kernel, I had two files that needed
> permissions changed before it would let me see the
> examples operate. Those files are, rmrtl and insrtl
> and they are both in the rtlinux-2.2 directory. all
> other instructions from linuxcnc.org worked flawless.
> 
>  Now for emc, first one you will come to is that you
> only need to edit two of the three files referenced on
> linuxcnc.org The rtlinux_2_0.def and the
> linux_2_0_13.def Now just DONT do the "fpermissive"
> edit inside these files. They still need to be changed
> so they point to rtlinux_2_2, and linux_2_2_14 as
> linuxcnc.org states.
> 
>   If you are going to run steppermod.o then comment
> out the period variable in your .ini file, and have a
> good time thats all there is too it.
> 
>   I still got lots of warnings about files being
> called more than once, but they dont seem to hurt
> things.
> 
>   I took better notes this time and all other steps
> are the same as on linuxcnc.org.
> 
> hope this helps someone,
> 
>    Andrew
> 
> >
> > --- Ray Henry <rehenry-at-up.net> wrote:
> > >
> > >
> > > Andrew
> > >
> > > Can you write up a note on your version and the
> > > differences.
> > >
> > > Thanks in advance
> > >
> > > Ray
> > >
> 
> __________________________________________________
> Do You Yahoo!?
> Get Yahoo! Mail - Free email you can access from anywhere!
> http://mail.yahoo.com/