Re: EMC documentation is emerging

[Dan Falck <dfalck-at-sprynet.com>]

Fred, 
I put an html copy in the "Dropbox" at linuxcnc.org.  I will insert it into the handbook a little later.

Thanks,
Dan

On Fri, 19 May 2000, you wrote:
> EMC folks,
> 
> I wrote up a 6-page description of the lowest level of the EMC software,
> the External Interface. This is where the mapping between functions
> called by the motion and IO controllers and the actual board functions
> (Servo To Go, parallel port) is done. It's an MS-Word file that I'll
> convert to PDF soon.
> 
> It's on the FTP site (or will be when the auto-copier moves it outside
> the firewall), at:
> 
> 	ftp://ftp.isd.mel.nist.gov/pub/emc/emcsoft/extintf.doc
> 
> Comments, please. I plan on gradually documenting my way up to the GUI.
> 
> --Fred