Re: stepper motor size

[Damon Gentile <dgentile-at-spf.fairchildsemi.com>]

Dovetal tables, milling cast iron,  hoping to go direct drive
for X & Y. Will need to go belts for Z & A.

-Damon

Hassan Rabe wrote:
> 
> are you using linear bearings slides or dovetail slides??
> what is the material that you are planning to mill??
> are the motors gonna be direct drive or using belts ??
> 
> Hassan
> ----- Original Message -----
> From: "Damon Gentile" <dgentile-at-spf.fairchildsemi.com>
> To: "Multiple recipients of list" <emc-at-nist.gov>
> Sent: Tuesday, May 06, 2003 2:27 PM
> Subject: stepper motor size
> 
> >
> >
> > Not directly related to EMC, but was wondering what  torque
> > rating would be reasonable for a small mill ? 8x24, 1.5hp jobbie.
> >
> > Thanks,
> > -Damon
> >
> >
> >
> >