Re: G-code question

["Hassan Rabe" <rabeh-at-student.gvsu.edu>]

am Still using BDI 2.10, thanks John...for the explanation.

Hassan
----- Original Message -----
From: "j.guenther" <vze2z45u-at-verizon.net>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: Friday, March 21, 2003 3:35 PM
Subject: RE: G-code question


>
> Hassan,
>
> The following g-code will in fact cut a circle using EMC with a radius of
> 1.171750 at location X 1.171750 Y0.0 at a feed rate of 2.5 inches per
> minute.
>
> G02 X 1.171750 Y 0.000000 I-1.171750 J 0.000000 F 2.50
>
> This generally works in EMC, although some versions have had problems with
> it.  I had trouble with this when I was running BDI 2.10 but the BDI 2.16
> release runs it just fine, IIRC.
>
> John Guenther
> 'Ye Olde Pen Maker'
> Sterling, Virginia
>
> > -----Original Message-----
> > From: emc-at-nist.gov [emc-at-nist.gov]On Behalf Of Hassan S. Rabe
> > Sent: Friday, March 21, 2003 15:02 PM
> > To: Multiple recipients of list
> > Subject: G-code question
> >
> >
> >
> > Hello list,
> >
> > I was wondering if there is any way to get EMC to inscribe a full
> > circle in one line of code.
> > or is there a G code that permits arcs more than 90 degrees.
> >
> > Regards
> > Hassan
> >
> >
> >
> >
> >
>
>
>
>