RE: Stepper Motor Resonance ?

Subject: RE: Stepper Motor Resonance ?
From: "Tim Goldstein" <timg-at-ktmarketing.com>
Date: Sat, 23 Nov 2002 11:19:30 -0700
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset="US-ASCII"
Importance: Normal
In-Reply-To: <003601c292d4$a4097340$a3058b90-at-h5g9t6>
Reply-To: <timg-at-ktmarketing.com>


Just as a method of testing try running the machine with another
controller package (TurboCNC can be booted off a DOS boot floppy). If
the problem is about the same you can pretty well figure that your
motors are just not up to the task. If the problem is improved it may be
the pulse spacing in EMC. 

Tim
[Denver, CO]
www.KTMarketing.com/CNC.html
Sherline products at Deep Discount
www.KTMarketing.com/Sherline

References:
- Stepper Motor Resonance ?
  - From: "Tim & Heather Smith" <thdsmith-at-bigpond.com>

Prev by Date: RE: Stepper Motor Resonance ?
Next by Date: Using the rs274 interpreter solo
Prev by thread: RE: Stepper Motor Resonance ?
Next by thread: Re: Stepper Motor Resonance ?

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact