Re: endpoint radius errors with i,j commands

Subject: Re: endpoint radius errors with i,j commands
From: Ray Henry <rehenry-at-up.net>
Date: Thu, 7 Nov 2002 11:06:40 -0600
Content-Transfer-Encoding: 8bit
Content-Type: text/plain; charset="utf-8"
In-Reply-To: <00e901c2867b$2b2157a0$6600a8c0-at-design>
References: <00e901c2867b$2b2157a0$6600a8c0-at-design>
Reply-To: rehenry-at-up.net



What BDI or age of EMC are you using?

Ray

On Thursday 07 November 2002 10:53 am, you wrote:
> Is there an easy way to eliminate this?
>
>  I've seen the article in the faq and haven't even attempted
> a recompile yet, I've tried setting my s/w (signlab)  to 4 dec.
> point precision (something you can't do with enroute) and
> am still getting the errors. I suspect this would increase my
> speed, as it presently cuts lots of short segments instead
> of a nice steady curve.
> Any suggestions?
>
> Erie Patsellis
> Shelbyville Design & Signworks
> 1309 W. S. 7th Street
> Shelbyville, IL 62565
> (217)774-4444
> visit our website at www.shelbyvilledesign.com

Follow-Ups:
- Re: endpoint radius errors with i,j commands
  - From: "Shelbyville Design & Signworks" <signworks-at-mcleodusa.net>

References:
- endpoint radius errors with i,j commands
  - From: "Shelbyville Design & Signworks" <signworks-at-mcleodusa.net>

Prev by Date: Re: control panel
Next by Date: Re: control panel
Prev by thread: endpoint radius errors with i,j commands
Next by thread: Re: endpoint radius errors with i,j commands

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact