Re: Lube output

["Les Watts" <leswatts-at-alltel.net>]

Hi Kurt

I use pressurized lube on my machine.
I just pull a signal to run it off of amp enable, which is controlled by
estop/estop reset
and machine off/on. Just hook that to a relay or whatever to your Bijur
pump.




Les

Leslie Watts
L M Watts Furniture
Tiger, Georgia USA
http://www.alltel.net/~leswatts/wattsfurniturewp.html
engineering page:
http://www.alltel.net/~leswatts/shop.html

----- Original Message -----
From: "Kurtis Martineau" <klmartineau-at-shaw.ca>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: Monday, September 09, 2002 11:41 PM
Subject: Lube output


>
> My machine has a lube piston that injects a shot of oil to all the moving
> parts throughout the machine.  This one shot event happens every 15
minutes
> (configurable duty cycle) as long as the machine is on.
>
> Can someone offer a solution to bridgeporttask/bridgeportio that would tie
> the lube output to the machine on/off function?  Keep the manual on/off
the
> way it is, but don't turn the lube off when the operator mode is toggled
> from auto or mdi to manual.  The emc output could be used to run a remote
> duty cycle timer.
> Of course it should be possible to have the duty cycle time base confgured
> through emc.
>
> Also, the low level sensor should prompt a warning, not inhibit the lube
> output.
>
> Kurtis
>
>
>
>