Re: AW: Hardware with existing EMC drivers?

[Ray Henry <rehenry-at-up.net>]

Hallo Ulf.

Mau at www.studioferraris.com has a couple of isa boards that he is 
working up EMC drivers for.  Since these are EU products, you might get a 
predictable cost.

Ray


On Tuesday 23 July 2002 09:33 am, you wrote:
> Hi Uwe!
> A student of mine is actually trying to make EMC run with Automata
> Products. Do you have AUTOMATA-Products? Another Student of mine has
> written drivers, the first one had to change them a bit according to
> the requirements of EMC. This is not too difficult once you have
> managed to read and write to your card. There is a good interface in
> emc to do this.
> Unfortunately there is a lack of good I/O-Cards. Especially for PCI.
> Someone should find one (or build one) and write a driver for it.
> Till
>
> -----Ursprüngliche Nachricht-----
> Von: emc-at-nist.gov [emc-at-nist.gov]Im Auftrag von Dambacher, Ulf
> Gesendet: Dienstag, 23. Juli 2002 15:09
> An: Multiple recipients of list
> Betreff: Hardware with existing EMC drivers?
>
>
>
> Hi
>
> I'm lurking on this list some time now, but now I did not have time to
> try EMC until now.
> So now I'm looking for the i/o-hardware:
>
> Besides Servo To Go, are there other (possibly cheaper) i/o-hardware
> solutions to control a servo?
> Who did already write a extintf.c for such a special card?
> Who has some combination of 12bit counter and D/A working?
> There was someone trying to create a parallel-port-interface with
> programmable logic, can someone mail me the link, I lost it...?
>
> Basically it is:     Is there a List of known-to-work-with-emc i/o
> cards?
>
> Greetings
> 	Ulf
>
> --------------------------
> Dipl.-Ing. Ulf Dambacher
>
> Institut für Werkzeugmaschinen und Betriebstechnik,
> Universität Karlsruhe
> Institute of  machine tools and production science,
> university of Karlsruhe, Germany
>
> FON +49 721 608 4014
> FAX +49 721 69 91 53
> ulf.dambacher-at-mach.uni-karlsruhe.de
> www-wbk.mach.uni-karlsruhe.de