Re: How to get a signal to controll spindle speed?

Subject: Re: How to get a signal to controll spindle speed?
From: j riach <jamie-at-riach.com>
Date: Sat, 18 May 2002 10:59:42 +0000
Content-Transfer-Encoding: 8bit
Content-Type: text/plain; charset="iso-8859-1"
In-Reply-To: <20020517153429.37173.qmail-at-web9104.mail.yahoo.com>
References: <20020517153429.37173.qmail-at-web9104.mail.yahoo.com>


On Friday 17 May 2002 15:36, you wrote:
> Hi list,
> Can anyone tell me how typically a mill with
> controllable spindle speed out the emc is being set
> up? I want somehow a possibility to controll
> laserpower by the emc software. I think I could use
> the "spindle speed" command for this purpose. 
you could use a simple  555 timer with an electronic variable resistor
these usually have up/down logic inputs which 'move' the wiper tap
and are very cheap & cheerful ,

Follow-Ups:
- Re: How to get a signal to controll spindle speed?
  - From: Ray Henry <rehenry-at-up.net>

References:
- How to get a signal to controll spindle speed?
  - From: Jacob Kranendonk <j_kranendonk-at-yahoo.com>

Prev by Date: Re: How to get a signal to controll spindle speed?
Next by Date: Re: How to get a signal to controll spindle speed?
Prev by thread: Re: How to get a signal to controll spindle speed?
Next by thread: Re: How to get a signal to controll spindle speed?

Date Index | Thread Index | Back to archive index | Back to Mailing List Page
Problems or questions? Contact