Re: where can i find G-code generator??

["Dean L. Hedin" <dlh2001-at-comcast.net>]

On Friday 10 May 2002 04:19 pm, Hassan S. Rabe wrote:
> good evening every body
> i produced a g-code using PRO/Engineer 2001, and it worked
> on the microkinetics controller....but its not working on
> EMC....so where can i find a suitable g code gernerator
> that goes fine with the EMC

What kind of error does EMC generate when it trys to run 
the PRO/E g-code?  

If you look at the RS274 spec and the PRO/E g-code you should be
able to see what the problem is.  I might be a simple search and replace
in your favorite text editor.  

>.....i don't think that i should
> write the G-code manualy? right?!?!?!

Belive it or not , I actually do (sometimes).