Re: AW: Can.t find output for mist on stg board

["joe bury" <joebury-at-hotmail.com>]

List,
   I'm using a BDI install. Dose it's ini run a simulated I/O?
                                                  Joe


>From: "Till Franitza" <xfa-at-isw.uni-stuttgart.de>
>Reply-To: emc-at-nist.gov
>To: Multiple recipients of list <emc-at-nist.gov>
>Subject: AW: Can.t find output for mist on stg board
>Date: Mon, 29 Apr 2002 02:52:16 -0400 (EDT)
>
>
>Joe,
>this must have sometring to do with the IO-section of your .ini-file. Is it
>possible that you only have simulated I/o?? Am I right? The problem is that
>there are only "pre-programmed" plc setups so you mught have to attach the
>e-stop-button too to keep you machine working with the i/o-controller you
>chose. If you are familiar with c-programming, you can program your own 
>plc.
>I would simply use an old one and change it according to my needs.
>Till
>
>
>-----Ursprüngliche Nachricht-----
>Von: emc-at-nist.gov [emc-at-nist.gov]Im Auftrag von joe bury
>Gesendet: Freitag, 26. April 2002 09:05
>An: Multiple recipients of list
>Betreff: Can.t find output for mist on stg board
>
>
>
>List,
>    Thanks for your advice to this point. We programmed in the mist command
>as to operate the air solenoid to raze and lower the "z" axis. When we 
>watch
>the screen we can see the flipping of the the mist on and mist off. But 
>when
>we probe for an output on the stg board. We can't find anything. We are
>assuming there would be a voltage output. Where do we look and for what? 
>Are
>there any steps we need to do to activate this output.
>                                           Thanks, Joe
>
>
>_________________________________________________________________
>MSN Photos is the easiest way to share and print your photos:
>http://photos.msn.com/support/worldwide.aspx
>
>
>


_________________________________________________________________
Chat with friends online, try MSN Messenger: http://messenger.msn.com