AW: Can.t find output for mist on stg board

["Till Franitza" <xfa-at-isw.uni-stuttgart.de>]

Joe,
this must have sometring to do with the IO-section of your .ini-file. Is it
possible that you only have simulated I/o?? Am I right? The problem is that
there are only "pre-programmed" plc setups so you mught have to attach the
e-stop-button too to keep you machine working with the i/o-controller you
chose. If you are familiar with c-programming, you can program your own plc.
I would simply use an old one and change it according to my needs.
Till


-----Ursprüngliche Nachricht-----
Von: emc-at-nist.gov [emc-at-nist.gov]Im Auftrag von joe bury
Gesendet: Freitag, 26. April 2002 09:05
An: Multiple recipients of list
Betreff: Can.t find output for mist on stg board



List,
   Thanks for your advice to this point. We programmed in the mist command
as to operate the air solenoid to raze and lower the "z" axis. When we watch
the screen we can see the flipping of the the mist on and mist off. But when
we probe for an output on the stg board. We can't find anything. We are
assuming there would be a voltage output. Where do we look and for what? Are
there any steps we need to do to activate this output.
                                          Thanks, Joe


_________________________________________________________________
MSN Photos is the easiest way to share and print your photos:
http://photos.msn.com/support/worldwide.aspx