Re: INIVAR ERROR

[Brian Greul <bgreul-at-swbell.net>]

Paul,
  thanks....
I will go grab the standard tarball and hit it again.
should I be using RT 2.2 with the 2.2.14 Linux kernel under RH 6.2?  Or
should I be using a different combination.?
-Brian
----- Original Message -----
From: "Paul" <paul.corner-at-tesco.net>
To: "Multiple recipients of list" <emc-at-nist.gov>
Sent: Friday, January 04, 2002 6:15 PM
Subject: Re: INIVAR ERROR


>
>
> Hi Brian
>
> First off - Could you post in plain text rather than that mime stuff that
OE
> 6.0 is sending. All I get here is a blank page unless I feed the email
> through another program...
>
> The reason inivar cannot be found is because your build is incomplete.
From
> your earlier post, you noted an error from
emc/plat/linux_2_2_18/bin/testppt
> along with a couple of other Errors. This is possibly due to an error in
one
> of the emcnml sources (at a guess). The EMC sources are designed to be
> compiled on many different kernel/rtlinux (and rtai) variations along with
> several different platforms. It is very easy for bugs to creep in that
only
> appear on one particular combination when using the CVS sources.
>
> If you want a source known to work with your setup, I would suggest using
one
> of the released tarballs - These can be found on the Sourceforge site or
> www.linuxcnc.org. If you want to get your hands dirty with C and C++
tracking
> down bugs, CVS sources are the way to go.
>
>
> Regards, Paul.
>
> On Friday 04 January 2002 10:32 pm, Brian Greul wrote:
>