Re: Z axis Offsets

[Paul <paul.corner-at-tesco.net>]

Hi Tim

Possibly an error in emcsh somewhere if the problem doesn't manifest itself 
in xemc. Most of the Tkemc is done via procedures, so if one axis is parsed 
OK, then all the others should also work.

Regards, Paul.


BTW Didn't know there had been a BDI 1.09 <g>


On Friday 28 September 2001  8:25 pm, Tim Goldstein wrote:

> I am running tkemc as a 4 axis configuration so it is definitley not that
> it is the last axis defined. As I mentioned the functionality seems to work
> properly with xemc as the front end. When I switched between front ends all
> I did was change the entry in the .ini file from tkemc to xemc with no
> other change to the .ini.

> > On Friday 28 September 2001 05:53, Tim wrote:
> > > Been doing a little work with Bridgett using BDI 1.09 with Ray's
> > > 8-1-2001 tarball replacing the original BDI EMC.